First Choice Insulation North York does insulation removal for bungalows, semis and townhouses in North York and nearby. When old insulation is wet, packed flat or full of mouse droppings, we take it out and clean up before anything new goes in. Insulation that is dry and clean but just thin can usually stay, and we will tell you that.

Wet insulation

Wet insulation comes out once the water source is fixed, not before. A roof leak around a chimney or vent soaks it from above. Condensation soaks it from below: warm house air hits a cold roof deck, turns to water and drips back down. Fibreglass and cellulose both stop holding heat when they are wet, because water fills the air pockets that do the insulating.

Soaked cellulose also mats into a heavy layer that sits right on the drywall. It can stay damp against the ceiling long after the weather clears, which is why a water stain keeps spreading across a bedroom ceiling weeks after the rain.

Our crew does not repair roofs. A roofer closes the leak first, and we tell you what we saw in the attic so you know where to send them. After that, wet insulation removal is straightforward. The damp material comes out, the attic floor dries, and new insulation goes in. A small damp patch that dries out clean can sometimes stay, and we will say so.

Flattened insulation

Flattened insulation has lost its depth, and depth is what keeps the heat in. Boxes stored on the attic floor and feet walking the joists press it into a thin, dense mat. An old leak does the same thing as it dries.

Packed-down insulation that is still dry and clean can often stay. We level it out and blow new material over the top, which is an ordinary attic insulation top-up. A flattened layer that is dirty, crusted from old water or full of debris comes out first. Lay new material over it and the new layer sits on the same problem.

Whichever way it goes, get the stored boxes off the attic floor. Otherwise the new layer goes flat for the same reason the old one did.

Mouse droppings and nests

Insulation with droppings, nests and tunnels through it comes out, but only after a pest-control company has dealt with the mice. Loose fibreglass and cellulose suit mice well: warm, and easy to dig through. Over time they cut runs through the layer, nest near the eaves and leave urine and droppings across the attic floor.

The pest-control company handles the animals and the gaps they came in through. We start once that is done, so new insulation is not going into an attic with mice still moving around in it. Rodent damaged insulation removal is a full strip. The soiled material is bagged out, we vacuum the attic floor down, and the space is ready for fresh insulation.

There is a separate page on mouse droppings in your insulation with the signs to look for and what happens once the mice are gone.

How it comes out

Insulation removal runs from your front door to a bare attic floor, with the rooms in between covered. Here is how our crew does it:

  • We lay drop sheets from the door to the attic hatch, over every floor and stair the crew will walk on.
  • The industrial vacuum stays outside at the truck with a hose run up into the attic. Old insulation goes down the hose, so none of it is carried through your hallway.
  • The vacuum empties into large removal bags at the truck, and the bags leave with us.
  • Once the bulk is out, we vacuum the attic floor down to the drywall and joists to pick up droppings, dust and loose debris.
  • With the ceiling bare, we seal the gaps around light boxes, plumbing stacks and wall top plates where house air leaks into the attic. They are never easier to reach than at this point.
  • Blown-in fibreglass or cellulose goes back over the sealed attic floor, to the depth your attic needs.

What we point out along the way

Opening up the attic shows things the old layer was hiding: a stain on the roof deck, a crushed vent, a bathroom fan blowing into the attic. Those are not jobs we do, but we show you what we found so the right trade can fix it. Our crew works the same way whether we are clearing one damp corner or a whole attic.

Old spray foam

Our crew removes spray foam too. It is stuck to the surface and will not vacuum out like loose fill, so we cut it away and scrape it off the studs, joists or roof deck by hand.

Spray foam removal usually comes down to one of two things. There is a leak behind the foam that someone has to find and fix, or a renovation needs the framing open. Once the foam is out, we talk through what should go back in. Sometimes that is not foam.

If it looks like vermiculite

Vermiculite is light and pebbly, grey-brown or gold, and lies loose between the joists like coarse gravel. It looks nothing like fibreglass batts or grey cellulose.

Some vermiculite insulation may contain asbestos, Health Canada advises, and leaving it undisturbed is the best way to minimize the risk. Its advice is also that it is prudent to treat any vermiculite insulation produced before 1990 as possibly containing some asbestos.

We do not touch it. If we open your attic hatch and see vermiculite, we stop and leave it exactly as it is. Before any work happens in that attic, have a qualified lab or an abatement firm test it. Removing vermiculite is a job for a licensed abatement firm, not for us. Once the attic is clear, we can come back for air sealing and new insulation. Until then, leave it alone yourself: don't sweep it, don't vacuum it, and don't store boxes on top of it.

More on Insulation Removal

FAQ

Common questions about insulation removal

Removing old insulation is worth it when it is wet, packed down and dirty, or soiled by mice. If it is dry and clean and just thin, it can usually stay with a top-up over it. We look at what is in your attic and tell you which one you have.

Wet insulation can stay only if the patch is small, the leak is fixed and the material dries out fully without matting or staining. Fibreglass that dries clean gets some of its loft back. Cellulose that soaked through settles into a dense, stained layer and should come out.

Yes, we remove old spray foam by cutting it away and scraping it off. It is more handwork than vacuuming loose fill because the foam is bonded to the wood. We check what is behind it, a leak for example, before deciding what goes back in.

We stop work and leave the vermiculite where it is. Health Canada advises that the best way to minimize the risk from vermiculite that may contain asbestos is not to disturb it. Have a qualified lab or abatement firm test it, since removal is a job for a licensed abatement firm.

Yes, a pest-control company should deal with any live mice and the way they got in before we start. Put new insulation into an attic that still has mice and it ends up soiled just like the old layer.

Get a quote

Get a spray foam or insulation quote in North York

Call (437) 563-1415 or send the form. Tell us which room is cold, drafty or hot. We will come look at the spot behind it and give you a straight written quote.

Call Text Quote